冷再生机高温环境作业4~5h后出现铁刨鼓转子不能提升故障，停机降温后故障随即消失。这是怎么回事呢？冷再生机租赁厂家为您解答。

After 4~5h of operation in high temperature environment of the cold regenerator, the iron planer drum rotor cannot be lifted, and the fault disappears immediately after shutdown and cooling. What's the matter? The cold regeneration machine rental manufacturer will answer for you.

该冷再生机铁刨鼓转子两侧安装有2个并联的升降缸，通过对升降缸活塞杆的上、下调节，可使铁刨鼓转子提升和下降，以控制转子对路面的洗刨深度。初步分析判断，故障原因可能是流入升降缸的液压油压力不足。

Two parallel lifting cylinders are installed on both sides of the iron planer drum rotor of the cold regeneration machine. The iron planer drum rotor can be lifted and lowered by adjusting the piston rod of the lifting cylinder up and down to control the depth of the rotor to the road surface. According to preliminary analysis, the fault may be caused by insufficient hydraulic oil pressure flowing into the lifting cylinder.

为了方便冷再生机后部液压系统布置，该冷再生机铁刨鼓转子升降系统由1台液压主泵向控制阀总成供给压力油，控制阀总成上共集成3组换向阀及配套阀组，分别控制統刨鼓升降缸、铁刨鼓后斗门升降缸和后轮转向缸。

In order to facilitate the layout of the rear hydraulic system of the cold regeneration machine, the planer drum rotor lifting system of the cold regeneration machine supplies pressure oil to the control valve assembly by a hydraulic main pump. The control valve assembly is integrated with three sets of reversing valves and matching valve groups, which control the planer drum lifting cylinder, the planer drum rear bucket door lifting cylinder and the rear wheel steering cylinder respectively.

我们分析了该液压系统，发现铁刨鼓升降缸与其他液压缸工作相互独立。随即将铁刨鼓升降缸回路及相关阀组单独分离出来，对工作原理进行分析、研究，以便对故障原因进行分析判断，从而确定故障点。

We analyzed the hydraulic system and found that the lifting cylinder of the iron planer drum is independent of other hydraulic cylinders. Then separate the lifting cylinder circuit of the iron planer drum and the relevant valve group separately, analyze and study the working principle, so as to analyze and judge the cause of the fault and determine the fault point.

冷再生机液压系统故障排除的分析相关内容就讲解到这里了，您对此有什么疑惑就来我们这里http://www.tclqgc.com咨询吧！

This is the analysis of the hydraulic system troubleshooting of the cold regenerator. If you have any doubts about it, please come to us http://www.tclqgc.com Ask!