冷再生机租赁价格

冷再生施工和机械租赁业务
筑路架桥,奉献社会;以人为本,追求卓越

冷再生机租赁多少钱

服务热线

18264104888

新闻中心

首页>>新闻中心>>使用冷再生机路面平整工作是如何进行的?

使用冷再生机路面平整工作是如何进行的?

来源:http://www.tclqgc.com/ 日期:2021-09-28 发布人:guanli
冷再是技术已经是道路施工中较为常见的一种机器了,在使用冷再生机后的路面平整工作该如何进行呢?
Cold recycling technology is already a common machine in road construction. How to carry out the pavement leveling after using cold recycling technology?
压路机对再生层稳压后,再生材料基本能够处于稳定状态,但仍不能完全消除再生机的轮迹,此时的轮迹深度约为0.5~1cm。
After the roller stabilizes the recycled layer, the recycled material can basically be in a stable state, but the wheel trace of the regenerator can not be completely eliminated. At this time, the wheel trace depth is about 0.5 ~ 1cm.
当完成两幅再生并全部稳压后,用平地机进行整平,一遍整平的目的是消除一幅、二幅右侧共三排轮迹。二遍整平主要是为了把刮刀前的再生料均匀地摊开,同时兼顾再生层的横向、纵向的坡度。再进行全作业段的找平。
After the regeneration of two frames is completed and all of them are stabilized, level them with a grader. The purpose of one leveling is to eliminate three rows of wheel tracks on the right side of one and two frames. The second leveling is mainly to spread the recycled material in front of the scraper evenly, and take into account the transverse and longitudinal slopes of the recycled layer. Then level the whole operation section.
冷再生机出租
Rental of cold regenerator
平地机对再生层找平后,如仍存在轮迹、麻面、局部骨料集中等现象,则需人工进行修补。方法是用再生新料将轮迹、麻面填满,所用新料应高出再生层0.5cm;将集中的骨料撒开,并用新料填充骨料的缝隙。
After leveling the reclaimed layer with grader, if there are still wheel marks, pitted surface, local aggregate concentration and other phenomena, it shall be repaired manually. The method is to fill the wheel trace and pitted surface with recycled new material, which shall be 0.5cm higher than the recycled layer; Scatter the concentrated aggregate and fill the gap of aggregate with new material.
此文关键词: 冷再生机出租  

推荐阅读/ Recommended reading

冷再生机在道路施工要求是非常高的,是要达到其结构寿命时就会产生深层裂缝、坑洞及拥包等损坏,从而导致道路使用性能的严重下降。作为一种

冷再生机施工的地域和限制! 2021-10-20
冷再生机租赁厂家告诉你冷再生机的四个应用优势! 2021-10-19
冷再生机在公路养护中的应用! 2021-10-18
使用冷再生机路面平整工作是如何进行的? 2021-10-15

推荐产品/ Recommended products